Related Blog
Related description
Problems that often arise in ceramic walls
Ceramics is a floor coating material and wall is well-intended for interior and exterior. But maybe we often encounter problems with ceramics installed on the wall and perhaps many of you do not know what is the cause and how the right solution to tackle the problem on the wall of the ceramic.
Ceramic that goes out can be because of the adhesive material that is the basic material to forge ceramic less or too much cement. In addition, the installation of ceramics is less accurate and proportional so that ceramic easily detached due to poor arrangement.
The way you can do is to use cement that corresponds to the composition of the adhesive material for the wall ceramic and use special tools such as spacers to give the ceramic spacing far more accurate and more neat installation.
The next problem that often appears on wall tiles is the ceramic nat that is easily dirty. Many of the causes of the NAT tile is easily dirty walls for example on ceramic walls that are in the kitchen is often terken aminyak and other cooking materials end in a long time will accumulate and become dirt that is difficult to clean.
Other examples such as wall tiles attached to the exterior of the NAT on the ceramic wall pages will easily become the place of moss growth, this occurs because the cavity on ceramic nat is less dense and high humidity will trigger the growth of moss and mushrooms on the ceramic.
The simple way that you can solve the problem is if the ceramic nat has been very dirty and difficult to eliminate then you can remove the NAT by dredge and replace it with a new NAT and match the color of the colour. Can also clean the NAT with routine cleaning the NAT with clean fluid.
Many activities in the House more and more substances that will stick to the ceramic either wall or another, especially the ceramic wall of the kitchen and the bathroom will usually have a higher humidity level so that the ceramic will easily appear spots.
In addition to the condition of ceramic also sometimes appears patches and mushrooms, this can also occur because there is a cavity behind the ceramic that can soak water from inside will increase the moisture of the water much higher and the quality of ceramics used is also less good. The solution can be done to often clean the surface of the wall so that the dirt does not accumulate and ensure the installation process of the ceramic is tightly and does not have a cavity for water can enter the wall.
The last problem that often occurs on wall tiles is that ceramic is broken while nailed and during installation process. This can be due to the lack of good ceramic quality or the tool used to install the ceramic too hard.
In general, this problem is a problem with the technical ability of ceramic installation of the artisan or the House chooser when you want to cook the ceiling for the hanger and pay less attention to the condition of the ceramic itself.
Solution to overcome this is to use a hammer or rubber wood so as not to damage the surface of the ceramic and for those who want to install goods hangers can use products hanger without using nails.
Having a wall with ceramic coating does have its own challenge. The article above are some ceramic problems that often occur in ceramic walls in your home along with solutions that you can do to solve the problem of ceramics.
Copyright © 2024 Sun Power Ceramics . All Rights Reserved.
